How to Cut Formica Countertop Already Installed

Our How to DIY Laminate Countertops (It'll Save You SO Much PDFs

Drill a starter hole inside the design template marks. The bit needs to be larger than the blade to your jigsaw. Screw a 12 (you can utilize the exact same piece you used for a rip fence if it is wider than the sink) to the center of your future hole. This will support the cut away so that its weight will not break any laminate when reaching the end of your cut.

Insert the blade into your starter hole and start cutting. Once again, constantly have the blade as much as complete speed before initiating the cut. You will find that it is a little more difficult to control a straight line with a jig saw but not to worry, the lip of the sink will cover any small slips over your mark.

Post-formed countertop (the kind with the important backsplash and drip edge) is quick and simple to set up-- as long as you do not have to cut it. Then it's awkward to handle, the backsplash needs a different cut, and the plastic laminate chips easily. Industrial fabricators use large stationary saws with 12"- or 14"- dia.

Few of us have that kind of devices, but you can get accurate results with a circular saw and a shop-built jig.  how to cut formica countertop  of individuals use to cut plywood, but it has a 2nd (much shorter) leg that covers around the backsplash. I built my jig out of scrap 3/4" plywood and used some remaining 1/2"- thick crave the cleats that direct the saw.

Cut a Laminate Countertop for a Sink - Fine Homebuilding

The smart Trick of How to Cut an Existing Laminate Countertop That Nobody is Talking About

Then install the cleat on the short leg of the jig and trim that side of the jig too. Because the edge of the jig is now perfectly lined up with the saw's blade, you position this edge on the counter top right on the line where you wish to make your cut.

Prior to making the backsplash cut, I set the countertop on sawhorses so it rests on the backsplash. This lets me make a nearly horizontal cut rather than attempting to hold the saw vertically. (NOTE: When cutting counter top, use a fine-toothed plywood cutting blade to lessen breaking in the plastic laminate.) When you have actually got the backsplash cut, set the countertop on sawhorses and cut the large section.